#30 Diameter 12" long Aircraft Extension Drill Bit. Made of high speed steel.

Small enough to fit in the palm of your hand, but provides enough leverage to tighten or loosen even the most stubborn nut. Features a ratcheting box end to ensure access to the tightest areas. 7 piece set. Flex Head.

Rivet Set, Straight, 1" Flush, 4" Long, .401 Shank

Aircraft Counterbore, 1/2" Dia., 1/8" Pilot Hole, 2-3/4" Len. Made of High Speed Steel. Requires 1400P series pilot.

3/8" Internal Nut Wrench with 1/2" square drive. This wrench is designed specifically to install and remove Lycoming Narrow Deck (ND), IO-390, and IO-580 internal wrenching nuts.

3/32" dimple size. 1" reach. Uses standard dimple die with .187" shank (see our 4263DP-X series). If you've been looking for a safe and economical way to make dimples, then this is the tool for you!

Titan multi-wedge pry tool sets are specially designed to gently remove door panels, dashboards, consoles, and more. These tools feature different wedge shapes that allow you to get under and lift pieces away without damaging delicate surfaces.

Bucking Bar is 2 lbs. Overall length 4". Heat treated. Polished working surfaces

Size 3-1/2" - 4", 120 Grit Silicon Carbide. For cylinder bore reconditioning. Provides proper finish for cylinder wall breaking without expensive fixtures.

Piper AD 2010-15-10 compliance requires the removal of a difficult to reach taper pin. This tool makes it easy to get the pin out.

Dzus Flush Head Panel Dimpler. Quickly makes dimples with exact countersink angle for Dzus FO and FJ series studs. Fits #5, #6, and #6.5 series.

Full-ratcheting crimper with an ergonomic angled shape that significantly reduces the level of exertion required to properly crimp terminals by as much as 60%. Adjustable crimp pressure wheel with safety release. For insulated R/Y/B terminals.