For #10 AN Screws. Similar to pop dimpler, but uses and allen screw to apply force. Each size comes with male & female die, allen screws and nuts and allen wrench.

Made for dimpling in restricted and hard to reach places where regular dimple dies won’t fit. Made in our shop with 7 ” Vise Grip plier. Machined tool steel dimple dies are T.I.G. welded to the Vise Grip jaws then polished. Manufactured by Avery Tools. M

Flush squeezer set. Made of steel and polished to a mirror-like finish. .187" (3/16") shank. 3/8" diameter by 1/4" long.

Gooseneck Rivet Set, 3/16" Universal Head (AN470) cupping, 7" Long, .401" Shank

Replacement aluminum head fits into our new ATS107A series Peening Tool. Great for driving pins, or for removing dents from steel and aluminum skins. Brass and Nylon heads are also available.

Squeezer and Dimple Die holder block is made of polyethylene to securely hold pieces without damage. Holds up to 25 standard sized dies having a 3/16" shank.

On page 9-28 of the RV-14 plans, setting the rivets on the elevator trailing edge wedge is addressed. The first step is to lightly (partially) set the rivets with (2) flat squeezer dies per figure 2 of the plans.

These clutch driven installation wrenches are designed for smooth, positive engagement in limited access areas. There’s no lost motion as with ratcheting assemblies. Tested to 220 inch pounds. 3/8" dia by 6" long, 1/4" drive.

These anti-vibe gloves are designed to reduce vibration from pneumatic and vibrating tools or repetitive motions. The glove features strategically places 5.0mm memory foam on the palm and thumb.

High Shear Rivet Punch, 1/4" Dia., 3-3/8" long. Uses a standard .401 rivet gun to remove High Shear and Huck rivets.

Nylon Head Peening Tool, 3" long. This versatile tool is great for forming sheet metal, driving pins, loosening bolts, etc. Works just like a mallet, but with a lot more control. Fits into any standard rivet gun or air hammer that supports .401" shank

Aluminum Head Peening Tool, 7" long. This versatile tool is great for forming sheet metal, driving pins, loosening bolts, etc. Works just like a mallet, but with a lot more control. Fits into any standard rivet gun or air hammer that supports .401" shank.