#30 size. Used with DH01 drill housing.

Size #10. 6" working length. Drill bushing type (most commonly ordered series). for drilling duplicate matching holes in overlapping sheets. Drill Guide Duplicators lets you drill directly by using the duplicator as a drill guide.

Allows you to extend the length of your threaded drill bits, or pilot cutters to reach into recessed areas. One end is threaded male 1/4"-28 to fit into your Angle Drill, and the other has a 1/4"-28 female to accept the bit. 10" Working Length.

Allows you to extend the length of your threaded drill bits, or pilot cutters to reach into recessed areas. One end is threaded male 1/4"-28 to fit into your Angle Drill, and the other has a 1/4"-28 female to accept the bit. 2" Working Length.

Get the same Shaviv® quality in a handy tool that clips to your pocket. Includes B10 blade in a convenient throwaway design. Deburrs holes as small as 1/8". One tool will last for up to 90 deburring applications.

#21 size. Used with DH01 drill housing.

Set of 5 pins for 1/8" holes. These pins are great for aligning overlapping holes. Just place the pin in the drilled hole of the lower sheet with the point facing up, then carefully place the overlapping sheet in place and tap lightly with a mallet.

Set of 5 pins for 3/16" holes. These pins are great for aligning overlapping holes. Just place the pin in the drilled hole of the lower sheet with the point facing up, then carefully place the overlapping sheet in place and tap lightly with a mallet.

A simple and easy to use drill press fixture that bolts to a drill press table and automatically centers tubing and other round stock for precise drilling. Guaranteed to produce a centered hole every time.

1/4" size. Used with DH01 drill housing.

#40 size. Used with DH01 drill housing.

Used to extend threaded drill bits, pilot cutters, or any other cutter with a 1/4-28 thread. Has a 1/4" Hex Drive on the shank end to fit a drill or screwdriver, and a 1/4-28 internal (female) thread at the other. 4" extension length.