With an overall length of only 7-1/8 inches (181 mm), the AVsMini easily goes to work in tight or awkward spaces where full-size aviation snips are challenged.

Taper diameter from 0.8974" to 1.1530". Brown & Sharp taper reamer. Flute length: 6-1/8". Overall length: 8-7/8". Straight Shank - Straight Flute.

Replacement cutter for P/N HC-1 (adjustable hole cutter)

Set of 5 pins for 5/16" holes. These pins are great for aligning overlapping holes. Just place the pin in the drilled hole of the lower sheet with the point facing up, then carefully place the overlapping sheet in place and tap lightly with a mallet.

Set of 5 pins for 1/4" holes. These pins are great for aligning overlapping holes. Just place the pin in the drilled hole of the lower sheet with the point facing up, then carefully place the overlapping sheet in place and tap lightly with a mallet.

2 lb hammer. Non-sparking brass hammers are recommended for use in areas where possible sparks may cause a safety hazard.

1-1/2" hammer. Pure rawhide hammer strikes sharply without scratching the surface of sheet metals.

Wiss Metalmaster® Aviation Snips are advanced metal cutting tools originally developed for cutting extremely tough alloys used in the aircraft industry. Straight (YELLOW) snips are ideal for cutting along lines and wide curves.

3/16" AN470 Straight Rivet Set. Designed to work with our new ATS Pro 200B Rivet gun. They will also work with any Jiffy 100 or 200 rivet guns. Overall length of 1-3/16".

.498" shank rivet set, 3-1/2" length. 1/4" diameter.

Heavy duty scribe that's used to mark metal parts prior to cutting. Tip is specially hardened to hold its point even when marking hard metals such as titanium. The tip is also easily replaced when it becomes dull.

Reproducing complicated patterns is a breeze with this 10” Contour Gage. The 3” deep fingers mold into the shape of any surface, creating a template which can then be used for reproducing complex contours and patterns when fabricating sheet metal.