#10 diameter. Used to mark overlapping holes and for locating or aligning holes. Overall length 3-1/2"

Replacement 1/8" blade for two-way deburring tool (TD002).

7" Overall Length Drill Extension. Used to extend drill bits, pilot cutters, etc. 1/4" shank on one end for air or electric drill and 1/4"X28 internal thread.

Size #21. 12" working length. Inverted drill bushing type. Inverted Duplicators allow you to locate a hole from the back of an overlapping sheet.

T-Handle Tap Wrenches. Designed for use with taps and many other tools turned by hand. Adjust and tighten to size by twisting knurled nut. Additional holding jaws are recessed inside the hole for gripping onto smaller sized taps.

Used to extend threaded drill bits, pilot cutters, or any other cutter with a 1/4-28 thread. Has a 1/4" Hex Drive on the shank end to fit a drill or screwdriver, and a 1/4-28 internal (female) thread at the other. 10" extension length.

Replacement blade for 3/32" two-way deburring tool (TD001).

Narrow blade for the SVBHD Deburring Tool. Works with steel and aluminum. Deburrs edges and holes down to 3/32".

Used to extend threaded drill bits, pilot cutters, or any other cutter with a 1/4-28 thread. Has a 1/4" Hex Drive on the shank end to fit a drill or screwdriver, and a 1/4-28 internal (female) thread at the other. 7" extension length.

#30 diameter. Used to mark overlapping holes and for locating or aligning holes. Overall length 3-1/2"

#40 diameter. Used to mark overlapping holes and for locating or aligning holes. Overall length 3-1/2"

#21 diameter. Used to mark overlapping holes and for locating or aligning holes. Overall length 3-1/2"