Size #40. 6" working length. Inverted drill bushing type. Inverted Duplicators allow you to locate a hole from the back of an overlapping sheet.

Size #40. 12" working length. Inverted drill bushing type. Inverted Duplicators allow you to locate a hole from the back of an overlapping

3/16" size. Used with DH01 drill housing.

Adapts standard drill bits for use with 1/4-28 threaded drills. Includes both collet and collet adapter. Overall of length of 1.125". #10 wire drill size.

Flexible Extension Bit Holder with locking, magnetic, and quick re­lease. Designed to flex and hold at various angles. 12x stronger magnet than standard bit holder. For use with hand or power tool driver.

Used to extend threaded drill bits, pilot cutters, or any other cutter with a 1/4-28 thread. Has a 1/4" Hex Drive on the shank end to fit a drill or screwdriver, and a 1/4-28 internal (female) thread at the other. 10" extension length.

Used to install miniature #8 corner style plate nuts (CWM).

Size #10. 6" working length. Inverted drill bushing type. Inverted Duplicators allow you to locate a hole from the back of an overlapping sheet.

Metric drill guide is sized for 17 drill bit sizes: 3, 3.3, 3.5, 4, 4.2, 4.5, 5, 5.5, 6, 6.5, 6.8, 7, 7.5, 8, 8.5, 9, 9.5mm.

Standard blade for the SVBHD Deburring Tool. Works with steel and aluminum. Deburrs edges and holes down to 1/4".

Size: 3/16". Deburrs the front, back or both sides of a hole in one pass. Works with any drill. Adjusts easily by turning a set screw in the shank to control the depth of cut.

Allows you to extend the length of your threaded drill bits, or pilot cutters to reach into recessed areas. One end is threaded male 1/4"-28 to fit into your Angle Drill, and the other has a 1/4"-28 female to accept the bit. 10" Working Length.