What every toolbox needs, a soldering iron with auto gas ignition. Ideal for starting and operating easily and safely under any condition. The high transparent nylon gas tank and ceramic heater prolong the service life.

This exceptional wire stripper easily strips wires from 22-8 AWG, is built with cast alloy chassis, and has a convenient recoiling spring design. The addition of fast compound wire stripping action and the stripping holes precisely machined.

A great tool to quickly and safely remove WEMAC eyeball cabin light & air vent housings for servicing. No more damage to the housing when removing. Manufactured with high friction elastomer tip for maximum grip.

24V, For use with Concorde AGM batteries. BatteryMINDer is #1 rated charger designed exclusively for use with either sealed or flooded lead-acid batteries. FAA and PMA approved and recommended by leading aviation battery manufacturers.

If you want the longest possible Life and Performance from your Batteries there is no other product better at doing this.

Designed to make the installation and removal of electric connectors easier and safe when if is necessary to loosen or tighten a threaded collar. Manufactured from a non-sparking steel alloy to insure complete safety.

Schauer’s new generation battery charger/GPU features computer-controlled battery charging. 12 volt charger, 20 cranking amps, 3 pin power connector.

This rugged multimeter is designed to give reliable, accurate readings under the most extreme conditions. Measures voltage, amperage, resistance, continuity, capacitance, temperature, frequency, and diode checks. Over 40 different functions.

No avionics installer should be without this tool. This handy tool makes the job of inserting a new wire into an already tied off wire bundle much easier. This tool is a great time saver.

Schauer’s new generation battery charger/GPU features computer-controlled battery charging. 24 volt charger, 20 cranking amps, 3 pin power connector.

Weatherproof heat shrink tubing offers waterproof protection and insulation on solder connections and components. This tubing features an adhesive-lined inner wall to seal out moisture. This tubing has a 3 to 1 shrink ratio with flame or a heat gun.

AMP PIDG® Electrical Butt Splice meets AS/SAE AS7928, Type II, Class 1 and 2 standards for aerospace electrical connections. For 18-22 AWG (red) single and multi-strand wires. 10 pieces per package.