Used to install #10 miniature one lug single-wing style plate nuts (SWM).

Used to install standard 1/4" one lug single-wing style plate nuts (SWS).

Adapts standard drill bits for use with 1/4-28 threaded drills. Includes both collet and collet adapter. Overall of length of 1.125". #21 wire drill size.

1/4" drill stop. Overall length 1-5/16". Used to stop the drill bit after reaching a preset depth.

Allows you to extend the length of your threaded drill bits, or pilot cutters to reach into recessed areas. One end is threaded male 1/4"-28 to fit into your Angle Drill, and the other has a 1/4"-28 female to accept the bit. 10" Working Length.

Double-Edged blade for SVBHD Deburring Tool. Deburrs both sides of holes as small as 1/8" at once. Works with steel and aluminum.

Standard blade for the SVBHD Deburring Tool. Works with steel and aluminum. Deburrs edges and holes down to 1/4".

Size: 3/16". Deburrs the front, back or both sides of a hole in one pass. Works with any drill. Adjusts easily by turning a set screw in the shank to control the depth of cut.

#10 diameter. Used to mark overlapping holes and for locating or aligning holes. Overall length 3-1/2"

Size #30. 6" working length. Inverted drill bushing type. Inverted Duplicators allow you to locate a hole from the back of an overlapping sheet.

#30 diameter. Used to mark overlapping holes and for locating or aligning holes. Overall length 3-1/2"

Allows you to extend the length of your threaded drill bits, or pilot cutters to reach into recessed areas. One end is threaded male 1/4"-28 to fit into your Angle Drill, and the other has a 1/4"-28 female to accept the bit. 4" Working Length.