Fast, efficient, thorough. Simply place the bearing between the plastic cones, tighten, and apply grease through the fitting on the end of the threaded shaft. Forces out old grease and evenly injects fresh grease into the bearing. Cone diameter is 4.5".

Size #10. 6" working length. Drill bushing type (most commonly ordered series). for drilling duplicate matching holes in overlapping sheets. Drill Guide Duplicators lets you drill directly by using the duplicator as a drill guide.

Economical yet sturdy clamps for general purpose use. Great for light duty welding and fabrication and in the home workshop. Galvanized or powder coat finish.

MET-ALL® Detail Polishing Kit will produce a showroom finish on bare metal, painted surfaces and fiberglass using a variety of Met-All polishes and premium bonnets.

Time-Rite "3A/B", (Used with I200B18). Made of vinylite. Will not contract or expand. Scale calibrations approved by engine manufacturers.

Replacement cable for Schauer JAC2512 series Battery Chargers. 3-Pin Power Plug at one end and Terminal Hooks at the other. 26" long.

High Shear Rivet Punch, 1/4" Dia., 3-3/8" long. Uses a standard .401 rivet gun to remove High Shear and Huck rivets.

Allows you to extend the length of your threaded drill bits, or pilot cutters to reach into recessed areas. One end is threaded male 1/4"-28 to fit into your Angle Drill, and the other has a 1/4"-28 female to accept the bit. 10" Working Length.

3/32" fuel tank dimple dies. Spring back.

On page 9-28 of the RV-14 plans, setting the rivets on the elevator trailing edge wedge is addressed. The first step is to lightly (partially) set the rivets with (2) flat squeezer dies per figure 2 of the plans.

Spring back dimple dies are precision CNC machined from aircraft quality heat treatable stainless steel & heat treated to Rockwell C42/46. Spring back angles on both dies make a superior dimple.

General’s protractor is a practical tool for measuring and duplicating difficult angles where a standard protractor or t-bevel cannot fit.