These charger/maintainer/desulfators are designed for all size and type 12-Volt Concorde® Aviation Batteries. If you want the longest possible Life and Performance from your Batteries there is no other product better at doing this.

Professional heavy-duty spark plug gap setting tool is completely portable for field use, yet precise enough to set gaps to within 0.001". Compatible with all Champion, and Tempest Massive Electrode Spark Plugs.

Also called a "Screw Knocker", "Woodpecker", or "Nut Buster", this is used o remove screws, bolts, nuts, etc. that are corroded or cannot be loosened by conventional methods. 10" long.

Quick Charge APU/Charger is designed to supply filtered DC bus power through standard APU receptacle in private and commercial aircraft. Delivers 28 volts at 25 amps to power 24 volt aviation systems.

This set of tools makes it easy to comply with AD 2011-10-09, which requires the inspecion of rollers, roller housings, seat rails, and engagement pin of both the pilot and co-pilot seat. The entire test can be accomplished in just a couple of minutes.

Diameter .025, 1 Lb.Can, Type 302. Stainless steel annealed, used to secure bolts, nuts or hardware subject to vibration. Comes in no waste 1 lb. dispenser cans. Type 302. MS-20995C; MIL-W-6713.

Accepts all 1/4x28 drill bits up to 1/4". Designed for drilling in those "impossible" areas. Features a compact 2,800 RPM motor and weighs just a little over 1 lb.

Bends Dzus "S" wire receptacles quick and easy. Fits all #5 and #6 series (1" and 1-3/8" rivet spacing) springs. Complete easy to follow instructions included.

Our Journeyman kit is for the aspiring A&P Mechanic or Homebuilder who needs a comprehensive professional kit, but is not yet ready for a Master Kit.

Used to access areas in and around vacuum pump flange. Precision formed angles reaches around obstacles and securely contacts nut. Ergonomic slip-resistant grip. Manufactured by Rapco.

Designed for RV-12 rivets that get pulled in close quarter or corner applications. Turned up angle at 10 degree to shift pop rivet stem and puller away from corner.

For pre-bending skin edges on lap joints and butt joints before riveting. Edge rolling will prevent skin edges from curling up during riveting.