This tool accommodates the two common series (diameters) of Airloc (A-Spec) studs #2 and #5. Each series has a hole for the stud to be placed in so that the cross pin can be easily and accurately installed.

A set of 4 drill stops in the most commonly used sizes: #40, #30, #21 and #12. Overall length 1-5/16". Used to stop the drill bit after reaching a preset depth. Overall length of 1-5/16".

In 1993 Avery Tools pioneered and developed the unique design of the first hand rivet squeezer that had inter-changeability between the yokes for pneumatic squeezers. The squeezer comes with two quick release pins for faster and easier yoke changes, and h

Alignment pins for use in installation of engine mounts on aircraft engines. Pins go in the holes ahead of bolts to help align everything without damaging the bolts.

Bends 5/8" diameter aluminum and copper tubing. Bend radius is 2-1/4". Open side type which slips over tube at any point. Makes smooth short radius bends up to 180°.

#21 Diameter, 1/4-28 thread. Two fluted 100 degree cutter with a 1/2" body diameter. These cutters excel in cutting highly abrasive material such as Kevlar, and other "difficult to machine" materials.

Connect to any air source. Sprays solvents or any cleaning solution. All metal design. Complete with siphon hose.

Includes two complete units: one for shrinking (p/n 4135), and one for stretching (p/n 4136). Shrinks and stretches metals, Shrinks metal down to a 2" or 3" radius. Works and forms metal up to and including 16 gauge.

A bright red heavy nylon banner that can be fastened to anything that needs removing before flight. Comes with a grommet and wire ring that can be attached to everything from gear pins to gust locks and pitot covers. Heavy duty vinyl is tear resistant.

The fleet of general aviation aircraft is aging. Mandated maintenance promotes reliability, but experienced pilots know mechanical issues can still arise, sometimes far from an open FBO.

Spacer shims are used with Compression Riveters to produce a precise rivet gap spacing. The correct gap spacing will produce consistent and uniform results. contains 2 each of the following shim sizes: 1/64", 1/32", and 1/16".

Accepts any dimple die or rivet squeezer with a 3/16” (.187) shank. A great resource when you need to do work in areas where a rivet squeezer will not work. The driver has a .401 shank to fit a standard rivet gun.