#30 Diameter 6" long Aircraft Extension Drill Bit. Made of high speed steel.

American National Standard wire gage 0 to 36, used for gauging non-ferrous wire and metals such as aluminum, copper, and brass.

0-600 inch-lbs in 10 inch-lb increments. 3/8" drive. Dial type. Accurate to within 2 inch lbs. Comes in case. Certification available upon request.

Make removing o-ring seals easier with this handy set of tools. With contoured and spoon shaped tips you don't have to worry about puncturing the ring as you hook under it.

Unibit Step Drill Bit, Cobalt HSS, 1/4" to 3/4", 9 Hole Sizes, 3/8" Shank IRWIN Unibit Cobalt is made of high speed steel, this step drill bit will last longer in the toughest of materials. Best suited for maintenance and repair work.

3/8" Diameter 100 degree, 3 flute, countersink cutter with integral #30 Pilot. Fits all 1/4x28 Threaded adapters. Made of hardened high speed steel (HSS).

Stainless steel automatic center punch.

For more than 60 years, the Standard Aircraft Handbook for Mechanics and Technicians has been the trusted resource for building, maintaining, overhauling, and repairing aircraft.

3/4" Dia, 1/4" Pilot Hole. Made of High Speed Steel. Requires AT404 series pilot.

This tool is designed for squeezing the flush rivets on the RV kit control surfaces that use the Van's aircraft #AEX aluminum wedge, and these control surfaces taper to a point at the trailing edge.

Tool designed for installing and removing rod end bearings without damage to the bearing, when screwing rod end bearing into nutplates. Tool puts the pressure on the housing - not the bearing.

2" Yoke for ATSRS series Rivet Squeezers.