Size #30. 6" working length. Inverted drill bushing type. Inverted Duplicators allow you to locate a hole from the back of an overlapping sheet.

1/4" size. Used with DH01 drill housing.

Size: 3/16". Deburrs the front, back or both sides of a hole in one pass. Works with any drill. Adjusts easily by turning a set screw in the shank to control the depth of cut.

Allows you to extend the length of your threaded drill bits, or pilot cutters to reach into recessed areas. One end is threaded male 1/4"-28 to fit into your Angle Drill, and the other has a 1/4"-28 female to accept the bit. 7" Working Length.

Double-Edged blade for SVBHD Deburring Tool. Deburrs both sides of holes as small as 1/8" at once. Works with steel and aluminum.

Mounts onto any 1/4-28 threaded angle drill, and adapts it for use with any 1/4" hex bit. Great way to use screwdriver bits with your angle drill. Positive locking mechnaism.

Size #40. 12" working length. Inverted drill bushing type. Inverted Duplicators allow you to locate a hole from the back of an overlapping

Used to install miniature #10 corner style plate nuts (CWM).

7" Overall Length Drill Extension. Used to extend drill bits, pilot cutters, etc. 1/4" shank on one end for air or electric drill and 1/4"X28 internal thread.

Size #30. 12" working length. Inverted drill bushing type. Inverted Duplicators allow you to locate a hole from the back of an overlapping sheet.

Size #21. 6" working length. Inverted drill bushing type. Inverted Duplicators allow you to locate a hole from the back of an overlapping sheet.

Replacement 1/8" blade for two-way deburring tool (TD002).