Used to install standard #6 corner style plate nuts (CWS).

Set of 5 pins for 3/16" holes. These pins are great for aligning overlapping holes. Just place the pin in the drilled hole of the lower sheet with the point facing up, then carefully place the overlapping sheet in place and tap lightly with a mallet.

Set of 5 pins for 1/8" holes. These pins are great for aligning overlapping holes. Just place the pin in the drilled hole of the lower sheet with the point facing up, then carefully place the overlapping sheet in place and tap lightly with a mallet.

Allows you to extend the length of your threaded drill bits, or pilot cutters to reach into recessed areas. One end is threaded male 1/4"-28 to fit into your Angle Drill, and the other has a 1/4"-28 female to accept the bit. 2" Working Length.

Set of 5 pins for 5/32" holes. These pins are great for aligning overlapping holes. Just place the pin in the drilled hole of the lower sheet with the point facing up, then carefully place the overlapping sheet in place and tap lightly with a mallet.

1/4" size. Used with DH01 drill housing.

#30 drill stop. Overall length 1-5/16". Used to stop the drill bit after reaching a preset depth.

#40 drill stop. Overall length 1-5/16". Used to stop the drill bit after reaching a preset depth.

Get the same Shaviv® quality in a handy tool that clips to your pocket. Includes B10 blade in a convenient throwaway design. Deburrs holes as small as 1/8". One tool will last for up to 90 deburring applications.

Size #10. 6" working length. Drill bushing type (most commonly ordered series). for drilling duplicate matching holes in overlapping sheets. Drill Guide Duplicators lets you drill directly by using the duplicator as a drill guide.

Size #10. 12" working length. Drill bushing type (most commonly ordered series). for drilling duplicate matching holes in overlapping sheets. Drill Guide Duplicators lets you drill directly by using the duplicator as a drill guide.

Used to install standard #8 corner style plate nuts (CWS).