For 14MM spark plug engines. Simply screw this plug into the spark plug port and slowly rotate the prop until the piston face makes contact to assist in locating your engine's top dead center postion (TDC).

Size 3-1/2" - 4", 120 Grit Silicon Carbide. For cylinder bore reconditioning. Provides proper finish for cylinder wall breaking without expensive fixtures.

Size .375". Flex-Hone allows you to precision fit valve stems to proper guide tolerances. It is self aligning to the guide bore and self compensating for hone wear.

Size .433". Flex-Hone allows you to precision fit valve stems to proper guide tolerances. It is self aligning to the guide bore and self compensating for hone wear.

5/8-18. 5/8 inch Diameter, 18 threads per inch. Includes 24 inserts, insertion tool, and tap

Replacement Cutting Wheel For 1154 Oil Filter Cutter.

This extension tube makes it easier to avoid obstructions when performing compression checks. Extends 8-1/2" to clear manifolds, harnesses, etc. For use with Eastern model E2A and E2M Compression Testers. 18MM threads fits Franklin & automotive engines.

Fast, efficient, thorough. Simply place the bearing between the plastic cones, tighten, and apply grease through the fitting on the end of the threaded shaft. Forces out old grease and evenly injects fresh grease into the bearing. Cone diameter is 4.5".

9/16-18. 9/16 inch Diameter hole, 18 threads per inch. Includes 24 inserts, insertion tool, and tap

Replacement blade for the Airwolf Oil Filter Cutter (model AFC-470)

Thread size: 8-32. Includes 24 inserts, insertion tool, and tap

This tool simplifies magneto timing on TCM (Continental) series O-300 A & B engines. No protractor on the spinner required, or other complicated tooling. Simply place it over the prop nuts and sight down the casing split to set the timing.