Our newest kit contains all the tools you need to build Van’s exciting new RV-12 Quickbuild Kit. Based on Van’s recommended tool list, you'll find virtually everything needed to successfully complete your RV-12.

This set of tools makes it easy to comply with AD 2011-10-09, which requires the inspecion of rollers, roller housings, seat rails, and engagement pin of both the pilot and co-pilot seat. The entire test can be accomplished in just a couple of minutes.

The RV Builder’s Kit has been completely revised to conform to Van’s recommended tool list for their very popular line of RV homebuilt airplanes. It contains all of the tools necessary to successfully assemble the RV-3/3B,4, 6/6A, 7/7A, 8/8A, 9/9A and 10

#5 Flush Dzus Flaring Tool for installing flare type grommets. This tool is required when installing flare type grommets. Requires Clamping Tool (not included). This #5 tool is designed to replace Beech Bonanza cowlings without removing the brackets.

Bends Dzus "S" wire receptacles quick and easy. Fits all #5 and #6 series (1" and 1-3/8" rivet spacing) springs. Complete easy to follow instructions included.

Our Journeyman kit is for the aspiring A&P Mechanic or Homebuilder who needs a comprehensive professional kit, but is not yet ready for a Master Kit.

Quickly and accurately measures standard cable diameters. Measures inch sizes: 1/16", 3/32", 1/8", 5/32", 3/16", 7/32", 1/4", 9/32", 5/16", 3/8". Measures millimeter sizes: 2, 2.5, 3, 4, 5, 6, 7, 8, 9, 10

For pre-bending skin edges on lap joints and butt joints before riveting. Edge rolling will prevent skin edges from curling up during riveting.

Accepts all 1/4x28 drill bits up to 1/4". Designed for drilling in those "impossible" areas. Features a compact 2,800 RPM motor and weighs just a little over 1 lb.

LocoLoc® Multi-compression hand swager with built-in cable cutter. Swages 1/16", 3/32", 1/8", 5/32", and 3/16" oval and stop sleeves, plus 7/32" stop sleeves. A total of 11 sizes plus the ability to cut up to 7/32" diameter aircraft quality steel cable.

3/16" maximum rivet capacity. Longer version of 0124-30C with double piston for extra power. Parts are interchangeable with chicago pneumatic squeezers. Accepts all squeezer sets with .187 shank.

Back riveting requires a hard flat surface to act as a bucking bar while you set the shop head of the rivet. This low carbon steel plate has flat ground surfaces to help you accomplish the task with minimumal effort. 3/8" thick X 4" wide X 15" long.