No avionics installer should be without this tool. This handy tool makes the job of inserting a new wire into an already tied off wire bundle much easier. This tool is a great time saver.

This tool accommodates the two common series (diameters) of Airloc (A-Spec) studs #2 and #5. Each series has a hole for the stud to be placed in so that the cross pin can be easily and accurately installed.

Alignment pins for use in installation of engine mounts on aircraft engines. Pins go in the holes ahead of bolts to help align everything without damaging the bolts.

A bright red heavy nylon banner that can be fastened to anything that needs removing before flight. Comes with a grommet and wire ring that can be attached to everything from gear pins to gust locks and pitot covers. Heavy duty vinyl is tear resistant.

Bends 5/8" diameter aluminum and copper tubing. Bend radius is 2-1/4". Open side type which slips over tube at any point. Makes smooth short radius bends up to 180°.

Includes two complete units: one for shrinking (p/n 4135), and one for stretching (p/n 4136). Shrinks and stretches metals, Shrinks metal down to a 2" or 3" radius. Works and forms metal up to and including 16 gauge.

#21 Diameter, 1/4-28 thread. Two fluted 100 degree cutter with a 1/2" body diameter. These cutters excel in cutting highly abrasive material such as Kevlar, and other "difficult to machine" materials.

Connect to any air source. Sprays solvents or any cleaning solution. All metal design. Complete with siphon hose.

Removeable nosepieces for 3/32", 1/8", 5/32", and 3/16" rivets. Includes case, tool wrench, and over 200 assorted rivets

The fleet of general aviation aircraft is aging. Mandated maintenance promotes reliability, but experienced pilots know mechanical issues can still arise, sometimes far from an open FBO.

Spacer shims are used with Compression Riveters to produce a precise rivet gap spacing. The correct gap spacing will produce consistent and uniform results. contains 2 each of the following shim sizes: 1/64", 1/32", and 1/16".

One of a kind drill attachment. Designed with a head thickness of only 7/16" for drilling in areas as close as 1". Fits any air or electric drill.