This wrench is specially designed to comply with CESSNA AD 96-12-22. It allows you to reach the adapter nut which must be torqued to a value within 50 to 60 foot pounds in compliance with the AD.

Silver, 3/32" Dia, 0"-1/4" Grip. Stubby Cleco is only 1.5" (38mm) high from end to end. Use it to get into tight areas and temporarily hold sheet metal sections in place prior to riveting. Requires cleco pliers (p/n 131).

Ratcheting, 4-indent, spring-loaded crimper used to install machined terminal pins in D-Subminiature (radio) connectors. Installs to AWG 20-26 wires.

45 deg., 1/4" Capacity, 1/4x28 Thread. Fits any air or electric drill. Dimensions are 7-1/2" long, 1-3/16" head height 3/8" side to center.

This handy Safety Wire Twister has been a workhorse tool since the early days of aviation. It's simple, elegant screwdriver-like design makes it easy to use with excellent results. Made of stainless steel.

6oz retainer for use with Semco 250A dispense guns.

3 cans of safety wire in sizes .021, .032, .041. 1 Lb.Can, Type 302. Stainless steel annealed, used to secure bolts, nuts or hardware subject to vibration. Comes in no waste 1 lb. dispenser cans. Type 302. MS-20995C; MIL-W-6713.

The Liberator is a 13 piece Hi-Lok Roller Ratchet System designed by an aircraft mechanic to solve real-world problems. Includes two 1/4" drive roller heads (rated at 80 in-lb torque) plus an assortment of arms to reach into any area.

Use this tool to quickly determine if your aircraft track guides are within tolerance. Simply run the gauge plug along each flap track while verifying that it will not enter the slot.

This specially designed bucking bar is required on the Van's Aircraft RV-10 and RV-14 for riveting inside the elevators. The bar dimensions are call out in the RV builders plans pages 9-12 of the control surface section.

Size 4-1/2" - 5", 120 Grit Silicon Carbide. For cylinder bore reconditioning. Provides proper finish for cylinder wall breaking without expensive fixtures.

Superior for back riveting flush rivets without damage to the skin surface. Spring loaded plastic guard holds down skin while riveting. Can also be used for "straight" riveting of flush rivets. Made in U.S.A.